MEP SHARK 282 SXI EVO 2025

Condition: new
published: 20/10/2025
25IND46882

Miniatura immagine annuncio MEP SHARK 282 SXI EVO 2025

Technical data

Condition: new
Year: 2025

Description

MEP SHARK 282 SXI EVO SEMI-AUTOMATIC BAND SAW New to the catalog SHARK 282 SXI evo, semi-automatic electro-hydraulic band saw, also available in manual and dynamic semi-automatic cycles, for cutting from 45° right to 60° left. – Machine with a single-axis microprocessor, managed by a latest-generation MEP controller designed exclusively for its semi-automatic saws. – Semi-automatic cycle: when the cycle starts, the following occurs: – vice closes and motor starts – head lowers for cutting – motor stops – head returns – vice opens. – Dynamic semi-automatic cycle: manually lowering the head to the desired position and pressing the button on the handle starts a semi-automatic cycle. – DOWN-UP CYCLE: When operating in the SEMI-AUTOMATIC cycle, the DOWN button stops the head and blade rotation at the end of the cut, keeping the clamp closed. The UP button completes the head's return to the top and opens the clamp. SOME FEATURES: – Console with all centralized controls, mounted on an articulated arm. – Low-voltage polyester membrane keypad with thermoformed buttons, tactile feedback, and an audible signal when pressed. – Display for: + diagnostics + alarms (description of causes) + input and output status + cut count + time taken for the cut + blade motor consumption + blade tension + blade speed + numerical display of the head position. – 24 V manual cycle control handle, IP55. – Complete program of various special cutting cycles. – Latest-generation hydraulic power unit, highly efficient and energy-efficient. – Large work surface with a rotating table mounted on a 265 mm diameter roller bearing, preloaded with a thrust bearing. – Dual belt rotation speed (36/72 m/min) with a card designed to accommodate an electronic inverter for continuous belt speed adjustment (from 15 to 100 m/min). – Head travel limits can be programmed from the console, based on the size of the bars being cut. – Manual blade tensioning via an electronic transducer, with display. – Pedestal with removable coolant tank.